Vital Signs Monitor User Manual User Interface
- 69 -
To rename the user configuration:
1. Select Menu > Default Setup > User Configure.
2. Select a configuration file needed to rename from the list and click on Rename.
3. Enter a name for the configuration file and confirm it.
10.5 Default Configuration
To set default configuration, select Menu > Default Setup. On the Default menu, users can
choose a factory configuration (adult, pediatric or neonate) based on the patient category. Also,
users can choose a user configuration saved in the monitor if it is available. For more information
about user configuration, refer to User Configuration.
To check the configuration currently used, select Menu > Default Setup. The one labeled with
● is current configuration. If there's no labeled configuration, it means the currently used
configuration is not one of them.
To Next Page
Loading...
