Edge Technologies V-65 Series - Page 45

6. OPERATIONS AND ILLUSTRATIONS V-65E-A
6-19
6.3.3.4 Particular program modify / enter password “258”
Parameter description︰This function can shift the bar feeder connect with
the lathe or auto test.
1.2M Generally value： Setting range ：
NO
1.5M Generally value： Setting value ：
Parameter description︰This function can shift the Logo on the screen of
the man machine.
1.2M Generally value： Setting range ：
NO
1.5M Generally value： Setting value ：
Parameter description︰This is the bar feeder required a bar end signal to
send the timing for CNC program, relative to the
description of sequence, please refer to the
description of sequence of movement signal in
article 6.2.3.
1.2M Generally value： Setting range ：
NO
1.5M Generally value： Setting value ：