Edge Technologies V-65 Series - Page 46

6. OPERATIONS AND ILLUSTRATIONS V-65E-A
6-20
Parameter description︰This is the bar feeder required a start signal to
send the sequence for CNC program, relative to
the description of sequence, please refer to the
description of sequence of movement signal in
article 6.2.3.
1.2M Generally value： Setting range ：
NO
1.5M Generally value： Setting value ：
Parameter description︰Please confirm the value of PLC input and output.
Then transfer their unit to mm or inch.
Previous page
Next page
Home page
1.2M Generally value： Setting range ：
NO
1.5M Generally value： Setting value ：
Parameter description︰Set all parameters to factory value. Select the
correct length of bar feeder to proceed. Otherwise
may cause problems.
Enter
Previous page
Home page
1.2M Generally value： Setting range ：
NO
1.5M Generally value： Setting value ：