34
EAS Accessories
EAS Overview
The CTS3’s functionality may be added upon by use of EAS
(Expandable Accessary System) devices. The CTS3 automatically
connects to any new EAS devices connected to it before it boots on, and
will alert the user.
Upon installation and loading of a new device, the following settings are
available:
1 DISPLAY NAME: Changing this item will change the name of the
PID, this name will be shown on the gauges and in the PID selection
menu.
2 DESCRIPTION: Changing this item will change the description of the
PID. This is shown when pressing the INFO button when assigning to
PID to a gauge.
3 DISPLAY UNITS: Changing this item will change the Units when
displayed on gauges.
4 SCALING: Selecting one of these scaling options will allow the
device to display the proper data once placed on a gauge. This selection
is required for your EAS accessory to work properly.
5 CURRENT SETTINGS: This will display the current settings
previously saved within the device.
6 RESTORE DEFAULTS: This will restore all items preloaded with this
device in relation within this EAS device.
TIP: These settings can be changed at a later time through the EAS
Settings Menu.
New EAS devices have been detected,
would you like to configure them
now?
Note: This can be done later from
the EAS settings menu.
To Next Page
Loading...