5
Contains FCC ID: TFB-1003
Contains IC: 5969A-1003
Edge Products CTS3 Programmer
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modications to this device not expressly approved
by Edge Products, LLC could void the user’s authority to operate the
equipment
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
RF Exposure
This equipment complies with radiation exposure limits set forth for
an uncontrolled environment. This equipment is in direct contact
with the body of the user under normal operating conditions. This
transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
FCC Compliance
To Next Page
Loading...
General