20
To remove the pressure switch:
1. Disconnect the power and lay the dishwasher on its back.
2. Remove the 1 screw that attaches the base cover to the base, then use a flat-
head screw driver to release the snap joints.
3. Remove the wiring harness connected to the float switch on the base cover.
4. Release the snap joint (using a flat-head screwdriver) that attaches the pressure
switch to the base, and remove the pressure switch.
5. Disconnect the brown wire from terminal 1 and the red wire from terminal 2.
6. Remove the pressure switch hose from the pressure switch.
Note: When reinstalling the pressure switch, ensure the switch is fully seated in the
bottom of the base bracket.
To Next Page
Loading...
