52
The descriptions of every setting in this menu will be given below:
This camera can obtain the IP address from DHCP
server automatically (if you have one), or set a fixed IP
address. Select „DHCP‟ to obtain IP address
automatically or „Static IP Address‟ to assign this network
camera with a fixed IP address.
When „DHCP‟ is selected, IP address parameters below
will be grayed out.
Specify the IP address for this network camera here.
Specify the subnet mask for this network camera here.
Specify the gateway address of the local network here.
Specify the IP address of DNS server here. Please input
IP address only. If you don‟t know the address of DNS
server, ask network administrator or your ISP for help.
Specify the IP address of backup DNS server here. When
primary DNS is unreachable, network camera will use the
IP address specified here as DNS server.
This field is optional.
Specify the port number of web management interface
here. If it‟s not 80, you‟ll have to add „:port’ after the IP
address / hostname of this metwork camera.
For example, if the HTTP port number you specified here
is 90 and the IP address of network camera is
10.20.20.30, then you have to input
‘http://10.20.20.30:90’
in the address bar of Internet explorer.
Select „Enable‟ to activate PPPoE function of this network
camera, select „Disable‟ to disable it.
Input the PPPoE username assigned by your ISP here.
Input the PPPoE password assigned by your ISP here.
Input the MTU (Maximum Transmission Unit) given by
your ISP here. Ask your ISP if you don‟t know what value
you should input here. Default value should work with
To Next Page
Loading...
