settings.
NOTE: IP address will be reset to default value
‘192.168.2.3’ also. You’ll need to change the IP address
setting of your computer if the IP address of your
computer does not begin with ‘192.168.2’, and subnet
mask is not ‘255.255.255.0’, or you’ll not be able to
connect to this network camera again.
If you found the network camera is responding slowly or
behaves strange, you can click this button to try to reboot
the network camera, this may help.
Click „Turn off LED light‟ button to switch the LED light of
this network camera off, so all LEDs on the network
camera will stop working, in case you don‟t want other
people know the camera is transferring data.
You can click this button again to switch LED lights on
again.
Click „Apply‟ to save settings and make the new settings take effect.
To Next Page
Loading...
