© Edwards Limited 2013. All rights reserved. Page 7
Edwards and the Edwards logo are trademarks of Edwards Limited.
Introduction
B800-00-880 Issue D
Note: The RS485/RS232 slide switch must be in the (default) RS232 position if the TIC is to be used to configure
the nEXT pump. Refer to Section 3.7.1.
The TIC is supplied with a Windows
TM
based PC program which allows the nEXT pump to be configured from a single
PC. The program has a simple user interface which means that it is not necessary to use the ASCII message protocol
described in Section 3.7. The TIC PC program has a facility to save multiple nEXT pump configurations which can then
be downloaded into other nEXT pumps.
To Next Page
Loading...
Need help?
General
