4. Ins
tallaon
4.1 Installaon safety
CAUTION: SAFETY INSTRUCTIONS
F
ollow all safety instrucons and take note of all appropriate precauons.
Possible hazards on the dry pumping system include electricity, process chemicals, and
Fomblin® (PFPE) oil:
▪ Refer to the safety manual P40040100 for safety informaon for the specicaon,
design, operaon and maintenance of vacuum pumps and vacuum systems.
Contact us for the safety manual.
▪ Contact us or the local service centre for more informaon for advice or assistance
on installaon.
▪ Do not remove the temporary covers from the system inlet and exhaust unl ready
to connect.
▪ Do not operate the system unless the inlet and exhaust are connected to the
vacuum and exhaust extracon system.
▪ Isolate the other components in the process system from the electrical supply to
prevent accidental operaon.
▪ Electrical supplies are pot
enally hazardous energy sources. Lockout and tagout
before you do the maintenance.
▪ Obey all naonal and local rules and safety regulaons when you install the
system.
▪ Tighten the cables, hoses and pipework during installaon to prevent a trip hazard.
▪ Make sure that the installaon area is clean and free from debris and
contaminaon before you install the pump.
▪ Make sure that all facilies given in this manual are available for the system to
perform correctly.
WARNING: BLOCKED EXHAUST PIPELINE
Risk of damag
e to equipment. Make sure the exhaust pipeline is not blocked. If an
exhaust isolaon valve is used, make sure that the pump is not operated with the
valve closed.
4.2 Unpack and inspect
WARNING: DAMAGED PUMP
Risk of injury to people or damage to equipment. Do not use the pump if it is
damaged. Failure to do so can result in injury to people and/or damage to
equipment.
05/2021 - ©Edwards Limited
Page 19A90301880_C
A90301880_C - Ins
tallaon
To Next Page
Loading...
Need help?
General
