PD00E0XKNXFI00020100_HANDBOOK_EN.DOCX
PD00E0xKNX KNX PRESENCE DETECTORS RANGE Handbook
Eelectron SpA, Via Monteverdi 6,
I-20025 Legnano (MI), Italia
Tel: +39 0331.500802 Fax:+39 0331.564826
E-mail: info@eelectron.com Web:www.eelectron.com
C.F. e P.IVA 11666760159
Tribunale di Milano 359157-8760-07
CCIAA Milano 148549
When button is pressed then counting time starts; if
the button is released before time exceeds TPL
time, device executes the command associated
with the event of "short press" and if, on the
contrary, TPL timeout expires and button is still
pressed then the command associated with the
The parameters and mode of transmission of
telegrams can be managed through "activation on
long and short press" are the same set with the
configuration "Activation of press / release " except
for the function of cyclic sending that is not
provided here.
Dimming
possible to
control a light dimmer using short and long press of
the buttons.
Each button uses 2 communication objects:
1 bit dimension for ON /OFF command
associated to short press operation
4 bit dimension for brightness regulation
associated to long press operation
darker behaviour and step of each long press
action.
Shutter and Blinds
Through the Shutter a
to control Roller Shutters or Blinds using short and
long press of the buttons.
Each input uses 2 communication objects:
1 bit dimension for STEP /STOP command
associated to short press operation
1 bit dimension for UP / DOWN command
associated to long press operation
associated to long press action.
Scene
In this configuration pag
button for scene management: learn and recall
scene commands.
These different behaviour (recall and learn) are
performed through two different actions (short and
long press) of the button.
Learn scene on long press action is enabled by a
parameter;
set the minimum duration of long press..
Number of the scene:
0 ÷ 63
This parameter sets the value of the scene you intend
to learn / recall (one per channel).
Remember that output devices (i.e. actuators, etc.)
generally can manage several scenes, each identified
by a value (that varies from 0 to 63); therefore is
important to set this parameter correctly and
matching the number set on the actuators.
Store scene on long
press
If disable, long press action is ignored and no telegram
is sent to the bus; if enable on long press action a learn
scene telegram is sent to the bus.
Object enable scene
learning from bus
If this parameter is enabled you have a communication
object (size = 1 bit) in order to enable / disable runtime
When this object receives a telegram "1" then the
function associated to the long press of the button
(send the telegram storage scenario) is enabled, when
with the long press is not sent.
To Next Page
Loading...