Eelectron KNX PD00E00KNX - Mur; Dnd; Loop Among Values; 15 Analog Input

PD00E0XKNXFI00020100_HANDBOOK_EN.DOCX
PD00E0xKNX KNX PRESENCE DETECTORS RANGE Handbook
Eelectron SpA, Via Monteverdi 6,
I-20025 Legnano (MI), Italia
Tel: +39 0331.500802 Fax:+39 0331.564826
E-mail: info@eelectron.com Web:www.eelectron.com
C.F. e P.IVA 11666760159
Tribunale di Milano 359157-8760-07
CCIAA Milano 148549
26/46
a short press is done the new color is sent on the
bus. When the device is powered off and on the last
selected color is kept in memory. The "Enable
sending color during transition" option allows you
to send all color transitions during long press so
that each color can be displayed on another device.
MUR / DND
This function allows you to configure a input to
send 1-bit commands with DND (do not disturb),
MUR (make up room) or reset both signals -
according to the sequence described below.
(column
defines which values are sent on the 2 x 1 bit
objects
cmd
Action
DND
MUR
Note
MUR
enable
0
1
MUR
disable
-
0
MUR
toggle
MUR enable/disable alternate
DND
enable
1
0
DND
disable
0
-
DND
toggle
DND enable/disable alternate
Loop
0
1
Loop among these 3 sets
1
0
0
0
It is possible to associate a color to each of the 3
states (DND active, MUR active, MUR & DND not
s also possible to send the same color on
the bus using a 3Byte Object DPT 232.600 RGB
value 3x(0..255)
Loop among values
With this function you can configure a button to
send a 1-byte value in sequence. The sequence is
composed of a number of values between 3 and 9.
Each time a pressure (or release according to the
"active edge" parameter) is done a value is sent
following the order set in ETS: from the first (A) to
the last ( I).
Two object are available:
<Input x> Loop Value Output
1 byte 0..255| CRT
This object is sto send the values of the sequence
< Input x> Loop Value Feedback:
1 byte 0..255| CW
this object is to receive a value from the bus; if it
corresponds to a value set in the sequence it bring the
same to the corresponding step.
15. Analog input
Input 3, if configured as an analog input for a
temperature probe, can be connected to a NTC
probe code eelectron:
TS01A01ACC (from -20°C to +100°C)
TS01B01ACC (from -50°C to +60°C)
Each input can be associated with the Temperature
Probe function or the Thermostat function
TS01A01ACC
Dimensions in millimetres
NTC resistance tolerance: ± 3%
Measure range -20°C ÷ +100°C
Cable: 2 wire single insulation
Cable colour: Black
NTC colour: Black
Warning:
keep at least 6 mm from all live parts