EASZ-2 Manual v1.12 - 12.2.2018 Page 3 / 30
IMPORTANT
In this manual a Warning identifies conditions and actions that pose a hazard to the Unit or the User and if
not followed may result in serious damage or injury.
WARNING: Prior to installing, connecting and commissioning the unit, you must thoroughly read all
the instructions in this manual and pay special attention to all instructions regarding Hazardous Areas.
WARNING: Before setting up your installation, check the model suits your application. The wiring of
the unit must comply with national and local regulations and be performed by qualified persons.
WARNING: Do not connect or disconnect any cables in hazardous areas and do not use non-approved
equipment in hazardous areas such as laptops, notebooks and mobile phones.
WARNING: To maintain the Unit’s certification only approved spare parts can be used.
1. Introduction to EASZ-2
The EESIFLO EASZ-2 Water-In-Oil Monitor is a full-bore inline and online highly accurate product
designed to continuously monitor the water content in a flowing hydrocarbon media (oil). It is inline
because it can be fitted easily into an existing pipeline and online because it can continuously monitor
and transmit the values to a remote location.
The unit is designed so that the fluid mixture flows through a fixed electrode assembly. This enables the
dielectric constant of the mixture to be measured as a variable capacitance which in turn produces an
analog or digital output.
Threaded ½” to 3”
Two glands for looped
2 wire power
IP66
Sensor Pipe all
316 Stainless Steel
Construction
Highly accurate with
response time 1s
To Next Page
Loading...
General