Efergy E2 - Single Tariff Setup; Step 1: Set Voltage; Step 2: Set Currency

14
9. Single tariff setup
The electricity monitor must be programmed with the correct unit cost per kWh if it is to provide
you with accurate cost readings. Set the tariff as follows (valid only if you DO NOT have a dual
tariff meter):
First enter the settings mode: Press and hold in [unit/set] for two seconds.
N.B. If no button is pushed for 20 seconds the display will go back to normal display mode
without saving any changes.
Step 1. Voltage
Press and hold in [unit/set] for two seconds. 230* flashes
(230 V is the default setting). Change the voltage using
the [◄] and [►] buttons if you have a different mains
voltage. Press [unit/set] to confirm and to advance to the
currency setting.
* Even if you have a 400 V supply, the voltage per phase
is 230 V.
Step 2. Currency
Set the correct currency (kr, €, $ or ₤) using the using the
[◄] and [►] buttons. Press [unit/set] to confirm and to
advance to the tariff setting.