（
left stick in American Hand
）
Note
Stay away from spinning propellers. Do not start the motors in narrow space or
where there are people nearby.
Keep controlling of the remote controller during the motors work. Do not stop the
motors during flight to reduce the risk of damage or injury.
After landing, power off the aircraft before turning off the remote controller.
Motors Test
After starting the motor, operate the right stick to perform the following actions:
Dial it up, the front two motors stop rotating.
Dial it down, and the rear two motors stop rotating.
Turn right, the right two motors stop rotating.
Turn left, the left two motors stop rotating.
The above steps can check if the motors work normally.
Nozzle Test
In the spray mode, press C and D buttons to turn on the water pump and the nozzle respectively.
Check if it can work normally.
Spraying Operation Modes
Spraying operation modes include Manual, A-B Route, Auto Operation Mode. Select the desired
mode for spray according to the application scenarios.
Operation Mode Switch
The aircraft is in attitude mode by default, and the aircraft can only be unlocked and taken
off in attitude mode. Three operating modes are optional: Attitude, Manual, and Auto.
① Auto
：
Move the left lever to the front position.
To Next Page
Loading...
