EG4 6000EX-48 - Page 33

31
3. LCD Setting and Display
Setting Program:
Program Description Selectable option
28
AC output mode
*This setting is only
available when the
inverter is in standby
mode (Switch off).
Single:
When selected, the unit is used in single
operation.
Parallel: When selected, this inverter is operated in
parallel system. The maximum number of
parallel units is 9.
3DUDOOHOV\VWHPIDXOWFRGHV:
Fault Code Fault Event Icon on
60 Power feedback protection
71 Firmware version inconsistent
72 Current sharing fault
80 CAN fault
81 Host loss
82 Synchronization loss
83 Battery voltage detected different
84 AC input voltage and frequency detected different
85 AC output current unbalance