EasyManuals Logo

EGO Induction Gx User Manual

Default Icon
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
product operating instruction
E.G.O. Germany (E.G.O. Elektro-Gerätebau GmbH)
document id.: 90.60160.286-001-04-A / state: 230 - released
designation: Induction Gx
page
10
of
43
2.3.6 Incorrect cable routing
Improper cable routings, which affecting e.g., sharp edges or hot areas, could lead to a damage of the
cable insulation. This could lead to a short-circuit risk or electric shock by having open wires.
Cable routing must be done in a way to protect the cables from overheat and mechanical impacts
(e.g., sharp edges).
The suitable cable material and cross-section must be selected.
2.3.7 Missing cable fixation for the hot appliance plug of the domino induction
A missing cable fixation for the hot appliance plug of the induction with built-in socket, could lead to a
pull-out of the plug within the assembly of the kitchen countertop. This could lead to a burning hazard.
An additional fixation of cables for the hot plug connector must be considered in a built-in cooktop.
2.3.8 Accessible voltage-supplied parts
Gx induction generators have accessible voltage-supplied parts (e.g., connection terminals, contact
parts…). Further accessible voltage-supplied parts can be accessible by using a thin metallic wire.
These could lead to a hazard of electric shock.
By a Gx induction generator delivery it must be secured that the holes in the mounting plate must
be designed according to IEC 60335-1 and IEC 60335-2-6.
2.3.9 Charged capacitors
Charged capacitors could lead to a hazard of electric shock, if the generator is accessible.
Check that the voltage of the capacitors is <60 V.
2.3.10 Unsuitable receptacles or wire material
Unsuitable receptacles or wire material. Insufficient electric contacts could lead to an excessive heating.
Just use suitable wires and receptables.
2.3.11 Other electronic devices
The induction is compliant with valid EMC standards and EMF guidelines and should not cause any
disturbances to other electronic devices.
In case that other electronic devices are not compliant with valid EMC standards and EMF guidelines,
disturbances to these not compliant devices (e.g., heart pacemakers, other electronic implants, other
household appliances…) could occur.
Persons with heart pacemakers or other electronic implants should consult their doctor or the
manufacturer of the implants to clarify if they provide a sufficient interference resistance.
2.3.12 Hot surfaces
Even if the cooktop itself is not heated during usage, the glass ceramic will get hot due to heat reflection
of the cookware. This leads to a risk of a burning hazard.
Do not touch the glass ceramic surface, which was used with the switched-on or recently used Gx
product under it.
document id.: 90.60160.286-001-04-A / state: 230 - released
view date: 2023-02-15 06:31:04 / user: BENDER

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EGO Induction Gx and is the answer not in the manual?

EGO Induction Gx Specifications

General IconGeneral
BrandEGO
ModelInduction Gx
CategoryHob
LanguageEnglish