EGO Induction Gx - High Voltage; Damage of Contacts; EMC Problems; Wrong Storage or Transportation

product operating instruction
E.G.O. Germany (E.G.O. Elektro-Gerätebau GmbH)
document id.: 90.60160.286-001-04-A / state: 230 - released
designation: Induction Gx
page
14
of
43
2.4.5 High voltage
The Induction generator may be damaged previously if the high voltage is applied directly in full
amount.

Only use high voltage testers which are electronically controlled und apply the high voltage
in a ramp.
2.4.6 Damage of contacts
Pollution on contacts (e.g., by touching them with dirty hands) could lead to damaged contacts or
contact problems.

Make sure that the contact areas are not polluted (e.g., by corrosion supporting substances).
2.4.7 EMC problems
A wrong cable routing or too long wires may cause EMC problems (interconnecting cable of
generators).

Perform the cable routing as recommended in the operating instruction and customer
documentation.
2.4.8 Wrong storage or transportation
A wrong storage, packaging or transportation can damage induction products.

Do storage and transportation as recommended in chapter 3.