product operating instruction
E.G.O. Germany (E.G.O. Elektro-Gerätebau GmbH)
document id.: 90.60160.286-001-04-A / state: 230 - released
designation: Induction Gx
Staff Required qualification
Qualified electrician
Knows the relevant standards and regulations for electrical
installations.
Has experience in using the relevant tools and equipment for
electrical installations.
Has knowledge of cooking appliances.
Has received training from the kitchen appliance manufacturer.
Tab. 3: Staff qualification
2.3 Residual risks
2.3.1 Installation with applied voltage
If there is voltage applied on the induction product by installation, electric shock hazard consists within
the installation.
Gx Induction coils, generators and systems must be installed or replaced by qualified staff only.
Power supply of the cooking appliance must be completely switched off and verified before all
installation or replacement work at an induction product.
2.3.2 Insufficient grounding
People could suffer an electric shock by having insufficient grounding.
Gx Inductions must be connected correctly and permanently with ground
potential.
Pay attention to the regional regulations and include testing and documentation.
2.3.3 Voltages at metal parts of the mounting plate
Metal parts of the mounting plates may carry dangerous voltages if there is a fault inside an induction
generator. There is a danger by electric shock.
It is necessary to connect Induction to protective earth (PE) conductor.
Ensure that PE conductor is well connected to provide low resistance.
2.3.4 Overloading the grid
A wrong selection of power per line conductor leads to an overload of the grid. The maximum power per
line conductor must be adapted to the fuse in the house installation.
Set the maximum permissible power dependent on your grid according to the manual of the user
interface.
2.3.5 Generator connection box
An open generator connection box provides touchable live parts. The assembly of the clamp terminal
with screw and the recommended housing cover is mandatory to achieve a proper protection against
accidental contact.
Assemble the suitable clamp terminal with screw and the recommended housing cover.
document id.: 90.60160.286-001-04-A / state: 230 - released
view date: 2023-02-15 06:31:04 / user: BENDER