product operating instruction
E.G.O. Germany (E.G.O. Elektro-Gerätebau GmbH)
document id.: 90.60160.286-001-04-A / state: 230 - released
designation: Induction Gx
2.3.13 Humidity
In case of liquid entry to Gx inductions, a hazard of electric shock consists.
Gx inductions must be protected from humidity and accessibility (e.g., liquid entry) from outside of
the cooking appliance.
2.3.14 Dust
In case of liquid entry to Gx inductions, a hazard of electric shock consists.
Gx inductions must be protected from dust.
2.3.15 Use of the induction outside its intended use
Induction Gx may be used only for the declared intended use (see chapter 2.1). Non-intended use of the
EGO induction units may lead to hazards that are not described in this document.
Use induction products just as described in this document and other applicable documents.
Use induction products not outside their intended use.
2.3.16 Non-intended objects on the glass ceramic surface
Not intended objects on the cooking surface could lead to a burning hazard.
Do not place or store any unsuitable objects on the glass ceramic surface.
2.3.17 Non-intended objects beyond the cookware
Not intended objects on the cooking surface could lead to a burning hazard.
Place the cookware directly on the glass ceramic.
Do not put any papers, cloths, trivets or other unsuitable objects beyond the pot.
2.3.18 Risk of unintended heating
Metal parts (e.g., a surrounding metal frame), which are located at the glass ceramic, may be heated up
unintendedly, if these are located too close to the inductors.
If the cooktop will be equipped with a surrounding metal frame, the overlap of the frame to the inner
side of the mounting plate must be as described in chapter 4.1. E.G.O. recommends a mounting
frame which is consisting of totally two similar parts, which are combined to a mounting frame.
2.3.19 High temperatures by using booster function
Using the booster function with a small amount of oil or fat may reach extremely high temperatures and
could lead to a burning hazard.
Booster function must only be used to heat-up water or usually frying procedures with oil.
2.3.20 Heating of magnetic tins
Closed tins may explode when heating up. Open tins may overheat because the temperature monitoring
is not adapted to magnetic tins.
Do not place and heat up magnet tins.
2.3.21 Use of damaged induction
If a Gx induction product is damaged (e.g., damaged through wrong transport and / or handling), it could
lead to electric shock.
Never use damaged induction products.
To Next Page
Loading...
General