Eighteeth HyperLight-G - Use of Exposure Function

6 Operation
Page 20 / 42
6.4 Use of exposure function
1. After selecting the exposure time,
short press the exposure button to
enter the ready state.
2. In the ready state, the screen will
display the inclination angle of the
machine to the ground plane. If the
exposure is not performed within 60
seconds, the ready state will exit.
3. At this time, you need to press and
hold the exposure button again for
exposure.
Warning
 During the exposure, keep
pressing the exposure
button until the exposure is
over. During the exposure,
if you release the exposure
button, the exposure will
stop immediately.