7 Cleaning
Page 28 / 42
user manual. If necessary, perform reprocessing
process again until the component is visibly clean.
Before packaging, make sure that the components
have been maintained according to the
manufacturer’s instruction.
Storage of the processed device in a dry, clean and
dust free environment at modest temperatures, refer
to label and instructions for use.
Make sure the power is off before cleaning and disinfecting.
Do not use cleaners other than ethanol (Ethanol 70 to 80 vol%), since
certain chemical combinations may deteriorate the HyperLight-G plastic
prematurely.
Never apply sprays or liquids directly on the surfaces of the device.
The HyperLight-G main body, base holder, backscatter shield, and the
power adapter are not designed to be subjected to any kind of
sterilization procedure.
To Next Page
Loading...
