9
Chapter 1
Introduction
●
Rear
6
8
7
5
1110
1312
9
5. Transportation handle This handle is used for transportation.
Attention
• Firmly grasp and hold the monitor by the bottom while grabbing the
handle, and carefully convey the monitor so as not to drop it. Do not
hold the sensor section on the front side of the monitor.
6. USB downstream port Connects to a peripheral USB device.
port supports quick recharging.
7. Security lock slot Complies with Kensington's MicroSaver security system.
8. Stand
*2
Adjusts the height and angle (tilt and swivel) of the monitor.
9. Cable holder Covers the monitor cables.
10. Main power switch
Turns the main power on or off.
: On, : Off
11. Power connector Connects the power cord.
12. Input signal connectors The following input connectors are located on the monitor rear in order
of left to right.
HDMI connector 1
HDMI connector 2
DisplayPort connector 1
DisplayPort connector 2
13. USB upstream port Connects to the USB cable when using software that requires a USB
connection, or when using the USB Hub function.
*2 An optional arm (or an optional stand) can be attached by removing the stand section.
To Next Page
