Eizo Monitor no picture and power indicator does not light. What to do?
If your Eizo monitor displays no picture and the power indicator does not light up, check whether the power cord is correctly connected. If the problem persists, turn the power off, wait a few minutes, and then turn it back on.
Why is the touch operation not working on my Eizo Monitor?
If the touch operation on your Eizo monitor is not effective, verify that “Use EEPROM” in the [Device] menu is not checked in the [Properties] settings of the touch panel driver. If it is already unchecked, perform a calibration. Note that other logged-in users may have altered the settings. You may need to reset the touch panel driver, restart “DMC Touch Panel Configuration”, or reboot your PC.
Why does my Eizo DuraVision FDX1001T say the input signal is out of range?
If your Eizo monitor displays a message indicating that the input signal is out of the specified frequency range, ensure that your PC's signal settings match the resolution and vertical frequency settings supported by the monitor. If necessary, reboot your PC or select an appropriate display mode using your graphics board’s utility.
Why is there no picture on my Eizo DuraVision FDX1001T?
Check if the power cord of your Eizo Monitor is correctly connected. If the problem continues, turn off the power, wait a few minutes, and then turn it on again.
Why is the calibration result not reflected on my Eizo Monitor?
If the calibration result is not reflected on your Eizo Monitor, click 'Handling Whole desktop' in the [Hardware] menu of the [UPDD Console] window, set 'Whole' in the [Desktop Area] window, and then perform the calibration.
Why is touch operation not working on my Eizo DuraVision FDX1001T Monitor?
If you are experiencing issues with touch operation on your Eizo Monitor, check whether 'EEPROM Calibration' in the [Calibration] menu is not checked in the [UPDD Console] settings of the touch panel driver. If it is checked, release the check before calibrating.
General| Contrast Ratio | 1000:1 |
|---|---|
| Touchscreen | Yes |
| Power Supply | AC 100-240 V, 50/60 Hz |
| VESA Mount | Yes (75 x 75 mm) |
| Resolution | 1280 x 800 |
| Input Ports | DVI-D |
| Touch Technology | Projected Capacitive |
| Input Signals | Digital |
| Response Time | 25 ms |
| Operating Temperature | 0 - 40 °C |
| Storage Temperature | -20°C to 60°C |
| Durability | IP65 |
To Next Page