Eizo Foris FX2431 - Page 23

23
Chapter 3 Settings and Adjustments
3
Perform the Auto Screen Adjust again with the analog screen
adjustment pattern displayed.
●  Toadjustickering,screenposition,andscreensize
automatically [Auto Screen Adjust]
(1) Display Pattern 1 of the screen adjustment pattern les in full
screen on the monitor.
(2) Choose [Monitor Settings] in the Setting menu and press .
(3) Choose [Advanced Settings] in the [Monitor Settings] menu and
press .
(4) Choose [Auto Screen Adjust] in the [Advanced Settings] menu and
press .
(5) Choose “Yes” with
t
or
u
, and then press .
Flickering, screen position, and screen size are corrected by the Auto
Screen Adjust function.
If the screen is not displayed correctly even after adjusting in
step 3 above, perform the adjustments according to the
procedures on the following pages. When the screen is
displayed correctly, go to step 5 “To adjust color gradation
automatically [Auto Range Adjust]”.
4
Perform advanced adjustments in [Advanced Settings] menu
of the Setting menu.
Adjust the clock, phase and position, in this order.
● To eliminate vertical bars [Clock]
(1) Choose [Clock] in the [Advanced Settings] menu and press
.
The [Clock] adjustment menu appears.
(2) Adjust the clock with
t
or
u
, and then press .
The adjustment is completed.
NOTE
• Press the control button slowly so as
not to miss the adjustment point.
• When blurring, ickering or bars
appear on the screen after adjustment,
proceed to [Phase] to remove
ickering or blurring.
NOTE
• Press the control button slowly so as
not to miss the adjustment point.
• When blurring, ickering or bars
appear on the screen after adjustment,
proceed to [Phase] to remove
ickering or blurring.