ACOM516 User Manual
Shenzhen Ejoin Technology Co.,Ltd. 45
If it is disabled, caller ID will not show on “call status” page.
If it is enabled, half of the bandwidth will be saved.
A jitter buffer is a shared data area where voice packets can be
collected, stored, and sent to the voice processor in evenly spaced
intervals.
If it is enabled, the last digit # of callee number will be removed.
If it is enabled, # will be appended in the callee number
SIP extension will show the mobile number when you call the SIM
in gateway.
Calls will be rejected when calling the SIM in gateway.
The numbers in white list will not be rejected if forbid GSM call is
enabled.
The prepare time until DTMF tone is detected.
The minimum of DTMF activity time.
The maximum time of alerting.
The maximum time of ring back.
The maximum duration for every call. System will hang up the call
automatically if the call duration excesses this value.
The maximum duration of silence from gateway. System will hang
up the call automatically if the silence duration excesses this value
Fake ring back time, gateway will do fake ring back when excesses
this value.
Stopping fake ring back when the callee is alerting.
Applying to calls from GSM network. The gateway will answer the
incoming calls automatically when excesses the value.
Applying to calls from IP network. The gateway will answer the
calls automatically when excesses the value.
RFC2833, SIP INFO and IN-BAND. The default one is RFC2833.
RTP Payload for DTMF, the default is 101.
The interval of RTP packages.
The initial port when RTP voice stream transmit the IP network.
Table 3.6.6-1