- 23 -
To make sure the installation of EK components was successful, we
recommend you perform a leak test for 24 hours. When your loop
is complete and filled with coolant, connect the pump to a PSU
outside of your system. Do not connect power to any of the other
components. Turn on the PSU and let the pump run continuously.
It is normal for the coolant level to drop during this process as air
collects in the distribution plate. Inspect all parts of the loop, and in
the eventuality, that the coolant leaks, fix the issue and repeat the
testing process. Ensure that all hardware is dry before the system is
powered on to prevent any damage.
TESTING THE LOOP
In order to obtain the best performance across
the entire lifespan of the product, it is crucial
to follow these maintenance tips.
1. DUST REMOVAL
It is mandatory to clean the dust every 2-3 months. EK recommends
using a vacuum cleaner or compressed air to blow the dust away.
The radiator is usually the dustiest, so pay special attention to
it. Do not forget to turn off the computer and unplug the power
supply. It is recommended to clean the dust outside.
2. CHECKING THE ELECTRICAL COMPONENTS
Once a year, you should check if the pump and fans are running
as they should. The pump and fans must run silently without any
rattling noises and must react to PWM duty cycle changes. All
imperfections may lead to overheating and, ultimately, breakdown.
3. CLEANING THE UNIT
Every year the unit should be thoroughly cleaned. You must let all
the coolant out. The radiator must be flushed, the pump checked
and cleaned. It is also recommended to change the tubing.
4. USING PARTS DESIGNED AND MANUFACTURED BY EK
It is recommended to use only genuine EK Water Blocks
liquid cooling gear and add-ons to prevent any performance,
compatibility, or warranty issues.
MAINTENANCE TIPS
To Next Page
Loading...