EKF Lactate Scout+ - Page 19

17
The number of the lactate concentrations
recorded per step test phase correlates to
the number of conducted tests. The count of
tested values occurs separately for every step
test phase and is automatically displayed on
the screen to the right of the respective step
test phase symbol (4). Onetestisintended
for every load step of the step test phase
(“LOAD”).
Upon inserting a new sensor, the last selected
step test phase is preset and is displayed
together with the next digit for the continued
test. Now you can perform this test or change
by scrolling up to the following phases or exit
the step test mode.
To exit the step test mode, turn the scroll
wheel directly following the test while the
sensor (5) is still inserted until “End” (6)
appears on the display. Conrm by pressing
the scroll wheel. Exiting is also possible prior
to a new test. In this case, after achieving test
readiness (7), scroll to “End” (8) and briey press
the wheel. The Lactate Scout+ is now in the
individual test mode once again (blinking drop).
Attention: One hour after the last step test
measurement, the measuring device automatically
returns to the individual test mode.
5
6
7 8