- 21 -
STEP 2
Prepare your suitably-sized PC chassis for the installation of the
radiator unit. The position of the unit in the chassis depends on its size,
fan mounting holes, and hardware that is installed. You must make
sure the unit fits into the case. Usually, cases already have standard
pre-drilled fan-mounting holes, and you should look for those with a
spacing of 105mm (for standard 120mm computer cooling fans) or
125mm (for 140mm cooling fans).
STEP 2
STEP 3
Align the holes of the radiator with the ones in the PC chassis.
Take four (4) UNC 6-32 x 5mm screws for each fan and guide
them through the holes in the chassis, then screw them into
the threaded holes of the radiator. Tighten them in a clockwise
direction using the enclosed Allen key.
STEP 3
Radiator
UNC 6-32 x 5 Screw
Fan
To Next Page
Loading...
