- 22 -
STEP 4
Install the compression fitting on both G1/4 extender openings of the
radiator. Tighten the fitting barbs in the clockwise direction.
The installation of the radiator and fans is now complete.
STEP 4
Fitting Barb
Fitting Ring
METHOD 2
STEP 1
Prepare your suitably-sized PC chassis for the installation of the radiator
unit. The position of the unit in the chassis depends on its size, fan
mounting holes, and hardware that is installed. You must make sure the
unit fits into the case. Usually, cases already have standard pre-drilled fan-
mounting holes, and you should look for those with a spacing of 105mm
(for standard 120mm computer cooling fans) or 125mm (for 140mm
cooling fans).
STEP 1
To Next Page
Loading...
