- 23 -
STEP 2
Align the holes of the radiator and fans with the ones in the PC chassis.
Take four (4) UNC 6-32 x 30mm screws for each fan and guide
them through the holes of the chassis and fans, then screw
them into the threaded holes of the radiator. Tighten them in a
clockwise direction using the enclosed Allen key.
STEP 2
UNC 6-32 X 30mm Screws
STEP 3
Install compression fittings on both G1/4 openings of the radiator.
Tighten the fitting barbs in the clockwise direction until the gasket
underneath is compressed.
The installation of the radiator and its cooling fans is now complete.
OPTIONAL: EK-Quantum Power Kit also comes with two pieces
of EK-Torque 90˚ Angled Fittings, which can be installed on the
Pump-Reservoir Combo unit, CPU unit, or Radiator.
STEP 3
Fitting Barb
Fitting Ring
Radiator
To Next Page
Loading...
