ELAD FDM-DUO - USB Interface Firmware Update; FPGA Firmware Update

ELAD FDM-DUO User Manual - Rev. 2.3 - 06/2016
© 2016 ELAD S.r.l. All rights reserved. No part of this document may be reproduced, published, used, disclosed or disseminated in any form or
by any means, electronic, photocopying or otherwise, without prior written permission of ELAD S.r.l.
92
8.2 USB interface firmware update
Download the latest version of the USB interface firmware here :
http://sdr.eladit.com/FDM-DUO/Firmware Releases/USB Interface Firmware/index.php?lang=EN.
Before starting the firmware update, disable all anti-virus programs to avoid any inconvenience.
Turn on the FDM-DUO and connect the USB RX connector to a USB 2.0 port of your computer. Unzip the
archive, launch the executable file inside and follow the instructions to update the firmware.
Do not disconnect the USB cable and do not turn off the FDM-DUO.
Once the update is completed, turn off and on the FDM-DUO.
8.3 FPGA firmware update
Download the latest version of the FPGA firmware.
Before starting the firmware update, disable all anti-virus programs to avoid any inconvenience.
Turn on the FDM-DUO and connect the USB RX connector to a USB 2.0 port of your computer. Unzip the
archive, launch the executable file inside and follow the instructions to update the firmware.
Do not disconnect the USB cable and do not turn off the FDM-DUO.
Once the update is completed, turn off and on the FDM-DUO.