D1650/D1651 INSTALLATION MANUAL
Page 16 © ELAN Home Systems, Inc. 2004 • All rights reserved. 7/04
ELAN HOME SYSTEMS
Factory Default
When your D1650 arrives, it is set to a FACTORY
DEFAULT condition. At some point during the life of
this amplifier it may be necessary to put the unit
back into Factory Default mode. If this unit is
moved to a different location or speaker type or
load are changed, the FACTORY DEFAULT proce-
dure should be used:
1. Turn the D1650 OFF using the rear Power
Switch.
2. Turn the unit back ON. The Front Display will
read ELAN.
3. Press and hold C+, C-, V+, and V- (all the front
panel buttons at once) while ELAN is dis-
played.
4. The Front Display will now read “FACTORY
DEFAULT”.
The Factory default settings are:
All channels Volume defaults to 50.
Lockout feature is Disabled.
ACE ™ Automatic Clip Eliminator is Enabled.
Display Brightness Levels
The blue Signal and Power LED brightness levels on
the Display can be increased or decreased from the
Front Panel. Press and hold C+ and V+ to cycle
between High, Low, and Off. The red Clipping LEDs
will remain at full illumination.
To Next Page
Loading...
