D1650/D1651 INSTALLATION MANUAL
Page 18 © ELAN Home Systems, Inc. 2004 • All rights reserved. 7/04
ELAN HOME SYSTEMS
Troubleshooting (cont.)
Audio is Unclear, Bass
Response Low
Speakers Out of Phase Verify that + of Amplifier goes to +
of Speaker (and – to -) on ALL
Speaker Leads.
Incorrect Source Playing on
Speakers
Make sure BUS A and/or BUS B
buttons in correct position.
2. Source Connected to Wrong
Input of Amplifier
Verify Source Input Connections.
3. Speakers Connected to
Wrong Speaker Outputs
Verify Speaker Connections.
Amplifier Will Not Power Up
1. Power Switch is OFF Turn it ON. Switch is Located on
Back of Unit.
2. Circuit Breaker Tripped ELAN Recommends the D1650 be
Installed on its Own 15 Amp Circuit
Breaker. Placing this Unit on a
Circuit Populated by Other Devices
can Cause Circuit Breakers to Trip.
3. Remote Turn-On Miswired Ensure That Any Remote Turn On
Cables are Connected At Both
Ends. A Cable Plugged into the
D1650 Remote In, but Not
Connected to a Sources Remote
Out will Remain in Mute Mode.
Audio Very Distorted in Areas
Using Volume Controls
1. Impedance-Match Settings
Incorrect
Set Impedance-Match Settings
Correctly.
2. Using Incompatible Volume
Control
Use Volume Controls Rated for 50
Watts or Higher.
1. BUS A and/or BUS B buttons
pressed.
To Next Page
Loading...
