R
15
4. To save your reading data into the batch:
• Manual logging: Press Save or Hold>Save (depending upon the Manual Logging [T] setting - see
page 26)
• Interval logging: Your reading data are saved automatically at the set interval.
5. When finished:
• Manual logging: Press >Exit Batching
• Interval logging: Press Stop>Yes.
Note: If an Auto Switch Off time is set, the gauge will appear to switch off after the set time delay, but in fact
while you are logging it will remain on in a reduced power state. In this state, during interval logging your
gauge will continue reading data into batch memory at the set logging interval. When the gauge is next
switched on the batch will reopen.
When you have finished you may want to:
• View the statistical analysis of the reading data - see “Statistics” on page 19.
• Transfer the reading data to your PC - see “Transferring readings to a computer [T]” on page 28.
To Next Page
Loading...
