R
25
To select the language, scroll to the required language and press Sel.
Auto Switch Off: Select the time delay before your gauge switches off automatically.
To select the time delay, scroll to the required value (Off, 1 minute to 10 minutes) and press Ok.
To return to the Setup menu, press Esc.
Note that Auto Switch Off is disabled when the gauge is powered by the USB connection.
Time/Date: Set the time and date and select the date format.
The Time/Date menu is displayed.
To adjust the time and date, scroll to Set Time & Date and press Sel. To adjust a value, press . To
move to the next/previous value, press . When finished, press Ok.
To set the date format, scroll to Set Date Format and press Sel. Scroll to the required format (DD/MM/YYYY,
MM/DD/YYYY, YYYY/MM/DD) and press Sel. When finished, press Back.
Beep Volume: Select the volume of the audio beeps.
To select the beep volume, scroll to the required value (0 = beep off, 5 = max volume) and press Sel.
Display: Select which readings (parameters) are shown on the display. The available parameters are:
RH (Relative Humidity), Ts (Surface Temperature), Ta (Air Temperature), Td (Dewpoint Temperature),T
Δ
(Delta Temperature), Tdb (Dry Bulb Temperature), Twb (Wet Bulb Temperature), SH (Specific Humidity).
The Display menu is displayed.
To select which parameters are shown on the display, scroll to Select Readings and press Sel. To toggle
the display of a parameter on/off, scroll to the parameter and press Sel. When finished, press Back.
To select which parameter is shown in the largest digits at the bottom of the display, scroll to Main Reading
and press Sel. Scroll to the parameter you want to select and press Sel. When finished, press Back.
To Next Page
Loading...
