www.elcometer.com
en-11
R
11 &SPARES ACCESSORIES (continued)
11.2 DOLLY CUTTERS
Standards or test methods will determine if the Inspector should cut /
score around the dolly prior to test to separate the test area from the
rest of the coating; information which should be recorded with the
results.
The Elcometer 506 is supplied with a dolly cutter and handle
appropriate for the dolly size included in the kit. Spare / replacement
cutters are available to purchase using the sales part numbers below.
Dolly Cutter Arbor T9990050 T9990050HCT
Dolly Cutter 50mm T9990050CT
Dolly cutter handles must be ordered separately - a handle is not
supplied with the dolly cutter accessory.
Description Part NumberFor Dolly Sizes (mm)
Dolly Cutter Handle T9990014 T9991420HCT
Dolly Cutter Handle T9990020 T9991420HCT
Standard Skirt 50mm T9990050S
I/D
†‡
O/D
Part Number Integrated Support Ring Dimensions
T9991420S 30mm 40.4mm
Thin Substrate Skirt T9990014T14.2mm
Standard Skirt 14.2 & 20mm T9991420S
Description Part NumberFor Dolly Cutter
Description Part NumberFor Dolly Sizes (mm)
Dolly Cutter 14.2mm T9990014CT
T9990020T 21mm 40.4mm
11.3 DOLLY SKIRTS
T9990050S 52mm 72mm
Dolly Cutter 20mm T9990020CT
Standard skirts are available for 14.2mm and 20mm dollies as well as
50mm dollies. Special skirts are also available for testing on thin
substrates to even out the load, as using a standard skirt on a thin
substrate may cause the substrate to bend or flex during test.
Thin Substrate Skirt 20mm T9990020T
T9990014T 16.3mm 40.4mm
†‡
I/D: Inner Diameter O/D: Outer Diameter
To Next Page
Loading...
