Electrabrake produces folds on thinner gauges and non-ferrous metals such as aluminium,
however, check the specification for heavier gauges.
To fill in unused portion under the clamp bar, make use of scrap pieces of sheet metal to create
uniformity of the bends in thicker gauges.
MAINTENANCE
ADJUSTERS
The adjuster screws at the end of the clamp bar control the thickness of the sheet metal between
the bending beam and its edge.
The heads for the screws are divided into 3 by centre pop marks. Use these marks as a reference
for repeat setting of the clamp bar. The bending gap will be approx. 1mm if adjuster screws are
both set so that the single pop mark is uppermost.
Adjuster set to 1mm
HINGE LUBRICATION
Grease all hinges once per month .
Hinge
WORKING SURFACES
Bare working surface may become rusty or tarnished. Recondition by filling off and clean up
surfaces with emery paper. Use an anti-rust spray.
TROUBLE SHOOTING
Prior to ordering a replacement electrical unit from the manufacturer please check the
following:
If the machine does not operate at all, check the pilot light in the ON/OFF switch.
If the machine is hot and power is available, leave the machine to cool and try again.
Do not pull the handle prior to starting – the start button must be pressed first.
If the bending beam is moved prior pressing the start button begin again and make sure the
handle is pushed fully back.
Instruction Manual for EB2500 (S5321)
To Next Page
Loading...