ANNEXURE 1
Basic Safety Precautions and Procedures:
Safety is all about preventing accidents. Personal injury typically occurs because safety precautions are
either not learned, or they are not practiced. The following information is intended to assist you with some
basic safety procedures and precautions to help ensure your safety when operating and servicing your
ELECTRABRAKE machine.
If you cannot operate basic tools, you should not attempt to maintain or repair your ELECTRABRAKE
machine. Contact the Manufacturer or Sales Agent if any repair or maintenance procedure is not
understood.
Keep a first aid kit near by. Be aware of and know how to use the contents of the first aid kit. It is also a
good idea to have a fire extinguisher handy just in case of an emergency.
SAFETY PROCEDURES:
Individual, electrical, machines, and operating safety precautions are relatively similar for all of the major
categories. Make sure to pay close attention to any and all safety cautions and warnings posted on the
appliance being operated or serviced. Understanding and adhering to these safety tips can greatly reduce
the risk of personal injury.
Individual Safety Precautions:
Protecting yourself from injury and harm is absolutely imperative. We strongly suggest that before you begin
to install, operate, maintain or service your ELECTRABRAKE machine that you strictly adhere to each of the
following:
Always wear gloves. A sharp edge on a machine or work peace can hurt and/or cut your hands.
Ensure gloves are worn at all times as the magnet body will become hot and can cause minor burns.
Ensure that your machine is adheres to the assembly instructions.
Be sure to wear safety boots. You can cause serious injury to unprotected feet by dropping any heavy
tools or work peaces.
Refrain from wearing loose clothing. Loose clothes can get caught in an operating machine.
Remember to remove any jewellery when operating or servicing your machine.
If you have long hair, keep it tied back.
Wear safety glasses to guard your eyes from any dust or flying debris.
Make sure you use the correct tools and that they are clean and in good condition.
Keep your work area well lit.
Use extreme caution when handling access panels, or any other parts that could have sharp edges.
Abstain from putting your hands into any section of the machine that you have not visually inspected
for jagged edges or sharp screws.
Inspect your work area to make sure it is clean and free of water or oil spills.
Ask for help if you need to move a heavy object.
Lift heavy tooling or work peaces with your leg muscles, not your back muscles.
MOVING ELECTRABRAKE BENDING MACHINE:
Moving bending machine into position. Use lifting brackets attached to Electrabrake columns.
Instruction Manual for EB2500 (S5321)
To Next Page
Loading...