Installing the eyebolts
To install the eyebolts, do the following:
1. Remove the three fly point covers from the suspension points.
2. Install M10 eyebolts and fender washers into the suspension points.
Warning!
Eyebolts must be fully seated and oriented in the plane of pull. Always use fender washers at
least 1.5 inch in diameter and 1/16 inch thick under the eyebolt to distribute the load on the
enclosure.
Figure 4.2: Eyebolt shown with washers (A) and without washers (B)
en 17
Electro-Voice Installation manual 2017.06 | 01 | F.01U.326.891
To Next Page
Loading...
