Electro-Voice ELX200-18SP-AP - Quick Setup

Quick setup
Full-Range loudspeaker
Models: ELX200-10P, ELX200-12P, and ELX200-15P
To set up a full-range loudspeaker, do the following:
Step Illustration
1. Connect the AC power cord from a
grounded line receptacle to the MAINS
IN.
MAINS IN
2. Connect the XLR, TRS, or RCA cable
from an audio source to INPUT 1 or
INPUT 2.
RL
QuickSmartDSP MONITOR|
AUX IN
OUTPUT
MASTER VOL
INPUT 1
INPUT 2
PUSH F OR DS P
3. Adjust the input gain to (infinity).
INPUT 1INPUT 1
4. Switch POWER to ON.
5. From the DSP home screen, increase
the input gain to the desired sound
output.
INPUT 1INPUT 1
6. Adjust the MASTER VOL knob to the
desired volume.
MASTER VOL
PUSH FOR D SP
2.3
en 11
Electro-Voice Installation manual 2017.06 | 01 | F.01U.326.891