Electro-Voice EVERSE 12 - Page 39

EVERSE Battery-powered Loudspeaker Amplifier DSP | en 39
Bosch Security Systems, LLC
User manual
2024-12 | 05 |
2. In both EVERSE loudspeakers, navigate to the BLUETOOTH menu in the Main DSP
menu.
3. In both EVERSE loudspeakers, select LINKSPEAKERS.
The LCD display will show LINKINGSPEAKERS... while establishing connection
between both EVERSE loudspeakers. When the connection is established, the menu will
display UNLINKSPEAKERS.
In the BLUETOOTH menu below the LINKING SPEAKERS, the stereo channel selection
will appear.
4. Select the appropriate stereo channel selection for each EVERSE loudspeaker: L+R
(mono), L, or R.
Note: This is stereo image from the audience's perspective, also known as House L & R.
LED menu
The LED menu shows power on and indicates limit. Available options for this selection are:
ON, OFF or LIMIT.
– ON - turns the LED on when the power switch is set to ON and system is not in standby
mode.
– OFF - turns the LED off.
– LIMIT - turns the LED off under normal operation. The LED brief blinking indicates the
limiter is activating. Short-term blinking is not critical because the integrated limiter
keeps distortion under control. Constant lighting of the LED indicates the sound is
negatively affected. If the LED is constantly lit, check the rear LCD for more
information. Reducing the output volume is strongly recommended.
The default is ON.
DIM menu
The DIM menu is used to dim the display when the display is idle for 30 seconds. Available
options for this selection are: ON or OFF.
The default is ON.
BRIGHT menu
The BRIGHT menu is used to determine the brightness of the LCD.
The range is 1 (darkest) to 10 (brightest).
The default is 5.
CONTRAST menu
The CONTRAST menu is used to increase or decrease the visibility of the LCD screen based
on lighting conditions.
The range is 1 (less contrast) to 10 (more contrast).
The default is 5.
STORE menu
The STORE menu allows you to create up to five customized user settings. Available options
for this selection are: BACK, 1, 2, 3, 4, and 5.
i
Notice!
The customized user setting name can contain a combination of alphanumeric characters
including spaces. The alphanumeric character range is A to Z and 0-9.
The name field length is 12 characters.
Storing customized user settings
To store customized user settings:
1. From the DSP control menu, scroll to STORE.
2. Push the MASTER VOL knob to select STORE.