Electro-Voice EVERSE Series - Quick Setup Guide

EVERSE Battery-powered Loudspeaker Description | en 13
Electro-Voice
User manual
2023-12 | 02 |
12 is one of the lightest 12-inch speakers in its class and weighs under 14kg (29.8lb).
Both EVERSE 8 and EVERSE 12 are water resistant to IP43 with the included
weatherized input cover.
2.3 Quick setup
To set up the loudspeaker:
Step Illustration
1. Connect the AC power cord from a
grounded receptacle to the MAINS IN to
ensure the battery has sufficient charge.
Note: It is recommended to leave the
loudspeaker plugged in and charging for
24hours the first time it is used.
2. Switch power to ON.
ON
OFF
3. Adjust the volume (VOL) to 0dB using the
MASTER VOL knob.
4. Push the input selection soft key for
INPUT1 or INPUT2 if using an XLR or ¼-
inch (6.35mm) cable, or push the input
selection soft key for INPUT3/4 if using
Bluetooth or 3.5mm mini jack.
Use the MASTERVOL knob to adjust
INPUT LEVEL to MUTE.
INPUT3/4
INPUT1 INPUT2
5. Connect an audio source using an XLR,
TRS, or TS cable to INPUT1, INPUT2, or a
3.5mm mini jack to INPUT3/4. Ensure
audio source is MUTE or at a low level
before making connection. After
connection is made, increase the source's
output to a reasonable level.
6. Adjust the INPUT LEVEL until the signal
peaks are just below maximum level or the
required output is achieved. If PK (PEAK)
is indicated, turn the level down until the
PK indication disappears.
Press the input selection soft key again to
exit the channel menu.
INPUT3/4
INPUT1 INPUT2
7. Using the MASTER VOL knob, adjust the
volume (VOL) until you get the required
output from the loudspeaker.