Electro-Voice EVERSE Series - Installation of Weatherized Input Cover

EVERSE Battery-powered Loudspeaker Operation | en 21
Electro-Voice
User manual
2023-12 | 02 |
Correct Incorrect
Always ensure the battery is properly
installed when operating in a wet or damp
environment.
DO NOT use in wet or damp environments
when the battery is not installed. This may
result in moisture entering the battery bay.
4.3 Installation of weatherized input cover
The weatherized input cover must be installed when the EVERSE loudspeaker is intended to
be used in wet or damp conditions. When the weatherized input cover is installed, the
EVERSE loudspeaker will be water resistant to IP43 standards. The EVERSE loudspeaker is
able to operate under battery power and Bluetooth® streaming for audio, and control with
the weatherized input cover installed.
To install the weatherized input cover:
1. Ensure that the weatherized input cover is fully intact, dry, clean and the gasket is in
good condition.
2. Ensure that the input panel on the EVERSE loudspeaker is dry, clean, and the mating
channel around the input connectors is dry and free of any dust or debris that would
prevent a good seal.
3. Power on the loudspeaker.