Electro-Voice EVERSE Series - System Status

EVERSE Battery-powered Loudspeaker Amplifier DSP | en 27
Electro-Voice
User manual
2023-12 | 02 |
7. MIX OUT - XLR output sends either the mix of all input signals or the stereo L or stereo
R signal to another loudspeaker or subwoofer.
8. FOOTSWITCH - ¼-inch TRS connector for connecting footswitch control to toggle FX
on/off.
9. Mobile device charging port - 5V 1.5A charging for mobile devices.
10. MAINS IN – AC connection is established via an IEC-connector.
11. POWER - Switch for power ON or OFF of the loudspeaker. The LCD screen lights up
when the power is turned ON, after approximately three seconds.
12. DC POWER OUT - DC power output jack for use with the 5.5mm outer diameter and
2.5mm inner diameter DC power cable included with the EVERSE-TRAY accessory. The
DC POWER OUT jack is capable of powering a wireless microphone receiver which uses
a center pin positive polarity and draws 500mA or less at 12 Volts DC, such as the
Electro-Voice RE3 or R300 wireless microphone receiver.
!
Warning!
The DC power jack is a power output. THIS IS NOT A CHARGING PORT. DO NOT connect a
DC power adapter or attempt to re-charge the EVERSE loudspeaker’s battery with this
connector. Doing so may cause damage to the loudspeaker and void of warranty.
5.2 System status
Normal
1
2
9
10
1
1
12
3 4 5
6 8
7
1. VOL - Indicates the master gain of the system in dB. The range is from -80dB to
+10dB, in 1dB increments.
2. INPUT1 - VU meter displays the signal level of INPUT1 into the amplifier INPUT1
connector. The display of P indicates 48V phantom power is switched on.
3. INPUT2 - VU meter displays the signal level of INPUT2 into the amplifier INPUT2
connector. The display of H indicates Hi-Z instrument connection is present on the
INPUT2 TRS connector.
4. INPUT3/4 - VU meter displays the signal level of INPUT3/4 into the amplifier from
either Bluetooth® streaming or 3.5mm mini jack connection.
5. MAIN - VU meter displays the signal level of the MAIN output.
6. DUCK - Ducking is activated on either or both INPUT1 and INPUT2.
7. AFS - Automatic feedback suppression is enabled.
8. BATTERY status - Indicates the battery level of the loudspeaker and if the battery is
charging (when MAINS is connected).
9. FUNCTION indicator - Indicates whether the system is in MIXER or BASIC mode.