EVERSE Battery-powered Loudspeaker Safety | en 5
Electro-Voice
User manual
2023-12 | 02 |
5. Condensation - In order to avoid condensation; wait a few hours before turning on the
equipment when it is transported from a cold to a warm space.
6. The apparatus shall not be exposed to dripping or splashing and no objects filled with
liquids, such as vases, shall be placed on the apparatus.
Danger!
To reduce the risk of fire and electric shock, do not overexpose this apparatus to rain or
moisture.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions. - Openings in the enclosure, if any, are provided for ventilation and to
ensure reliable operation of the apparatus and to protect it from overheating. These
openings must not be blocked or covered. This apparatus should not be placed in a
built-in installation unless proper ventilation is provided or the manufacturer’s
instructions have been adhered to.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat or in direct sunlight.
9. No naked flame sources, such as lighted candles, should be placed on the apparatus.
10. Power cord options:
– Mains plug
– Use a 3-pin mains plug that is registered with the Safety Authority.
– Use a 2-pin mains plug that is certified
1
to EN 50075/IEC 60083 Standard C5
(shown in the Appendix S of Singapore Consumer Protection (Safety
Requirements) Registration Scheme Information).
– Flexible cord
– Use a double insulated flexible cord that is certified
1
to the relevant IEC standards.
1
Certified by member of IECEE CB Scheme.
– Appliance connector
– Use an appliance connector certified
1
to IEC 60320.
1
Certified by member of IECEE CB Scheme.
11. Do not defeat the safety purpose of the polarized or ground-type plug. - A polarized
plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wider blade or the third prong are provided for
your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
12. Mains powered equipment shall be connected to a mains power outlet socket with a
protective earthing connection. An external, readily operable, mains plug or all‑pole
mains switch shall be installed.
13. To completely disconnect AC power from this apparatus, the power supply cord must
be unplugged.
Warning! To prevent a shock hazard disconnect all power sources prior to
system installation.
14. Unplug the apparatus during lightning storms or when unused for long periods of time.
15. Protect the power cord from being walked on or pinched particularly at plug,
convenience receptacles, and the point where they exit from the apparatus.
To Next Page
Loading...
Need help?
General
