5
ARCHIMEDE LCD SERIES - ENG
ELECTROIL
4. WARNINGS AND RISKS
This Inverter can not be installed in explosive environments.
The following instructions give you important information for correct assembling and use of the
product. Consequently, before installing the device, these instructions should be read by people
who assemble or use it; besides, these instructions should be available to all person assigned to
device setting and maintenance.
Skilled workers
The installation, the starting and the maintenance of the product must be done by skilled workers, in order to avoid
the risks of an incorrect use.
Dangers due to missed respect of the safety regulations
Failing to respect the safety regulations, could endangers others and damage the devices, which can lead to loss of
warranty. The results of the non-observance of the security rules can be:
• Malfunctioning of the system
• Danger to others, by electrical and mechanical events
Security for the users
All the accident-prevention rules must be respected.
Security rules for assembling and control
Assembling, controlling and servicing the device must read this manual. All operations on this device must be done
when the system is no longer in motion and without voltage supply.
Alterations and spare parts
Every machine, equipment or system alteration must be authorized by the manufacturer. For you and your system
security, it is therefore important to use only original spare parts. The use of non-original components may endanger
others and can lead to loss of warranty.
Wrong working conditions
The working security is guaranteed only for the conditions described in chapter 3 of this manual. The values shown
cannot be exceeded!
Only a skilled worker can assemble and install this device.
The installer has to be careful connecting the ground wire directly to the inverter frame (an eyelet
terminal is preferred; for having a good contact it is important to remove the paint from the contact
surface). It is necessary to avoid ground loop, that is like an antenna for EMC emission.
Power supply must be admitted on working condition; don’t lift or carry the motor pump (or the motor
connected to the inverter) lifting it from the inverter.
To Next Page
Loading...
