9
• The item is white on a blue background and
the caption is blue.
This function is selected:
SMART MODE
Control interlock
To lock the control panel, press buttons 3 and
4 simultaneously, the screen will display the
Locked icon.
To unlock the control panel, press buttons
3 and 4 as well, the screen will not show the
Unlocked icon.
Heating temperature setting
Use buttons 3 and 4 to set the target heating
temperature. Button 3 to decrease the value,
button 4 to increase the temperature value.
The available range is from 30 to 75 ˚C.
No Frost — Anti-freeze function
This function keeps the tank temperature below
5° C to prevent the tank from freezing. This
function is enabled by default.
Bacteria Stop
The professional antibacterial heat treatment
function of the water stops the proliferation
of bacteria, such as ligionella, which grow
when the device is not used for a long time.
The water in the appliance is heated to a
temperature of 70˚C and maintained at this
temperature for 20 minutes. This function will be
triggered if the temperature in the tank has not
risen above 70˚C for a week.
Timer
There are 3 timers available for setting in the
device. They can be activated, deactivated
and changed. By default, these timers are off.
To change Timer 1, select it and press button 2,
you will go to the settings of this timer. The time
for which the hot water is needed and the timer
repeat, as well as the switching on and off of
Timer 1, are available for setting. Changing the
settings of Timers 2 and 3 is done in the same
way.
By default, all three timers have the same
settings:
• the time by which the water must be
heated — 17:00;
• repetition — once;
• timer off.
Smart function
When Smart is active, the water heater
remembers your settings for 7 days and then
repeats them for the next 7 days. The device
remembers
The function allows you to prepare the water at
the desired temperature only when you need
it, thereby saving energy costs. The function
allows you to prepare water at the desired
temperature only when you need it, thereby
saving energy costs. The rest of the time the
temperature in the tank is maintained at 40 °C.
Display brightness
Display backlight brightness control: 50 or
100%.
Auto Display Off — Display Timeout
Set the display timeout. When this function is
activated, there are three selectable values: 15,
30 and 60 seconds. The default setting is 30
seconds.
Date and time
This section allows you to set the current date
and time of the device.
The correct time and date are necessary for
the Timer and Smart functions to work properly.
Language
The interface language setting is available in
English.
ENGLISH
To Next Page
Loading...
