Electrolux FGCD2456QW User Manual

14
“i5F“– code: DP motor plug
connection
• Error will be set if motor connection is detected
wrong based on motor currents measurements.
If currents are inside the thresholds (+/- 22 mA);
debounce is set to 1.6 seconds
• This code is also possible if a phase is detached
or if a winding inside the motor is broken.
“i60” Code - family: Heating
Element Problem
“i60” – code: heating
• The error is stored and displayed only in service
mode; the washing programme continues without
the activation of the heating element
• During the heating phases, the rise in temperature
is monitored with an update every 3 min.
• Within these 3 minutes, the temperature must rise
by at least 1 °C.
“i61” – code: heating over temperature
• If water temperature is detected higher than 78°C,
cycle is stopped.
“i70” Code - family: Thermistor
problem
“i70” – code: NTC sensor value out of
range
• The error is stored and displayed only in service
mode; the washing program continues without the
activation of the heating element
• Monitoring starts immediately after the program
has been started
• The voltage measured at the ends of the NTC
must be between 0.04 and 4.7 V
• Time limit set: 10 seconds.
“i80” Code - family: Auto Door
Opener
“i80” – code: Auto door opener
malfunction
• The error is set if the auto door opener sense
signal indicates that it has left the normal position
unintentionally while running a cycle,
• Or if the auto door opener times out without
reaching starting position three times while
retracting.
• Timeouts are defined in MCF
• Abort program and display error
“i81” – code: Auto door opener
warning
• The warning is set if the auto door opener sense
signal indicates that it has left the normal position
unintentionally,
• Or if the auto door opener times out while
opening the door and does not leave the starting
position,
• Or if the auto door opener reverses direction while
opening the door and reach the inside position
before expected (door blocked),
• Or if the auto door opener times out while
retracting.
• Timeouts are defined in MCF
• The warning is not displayed, the cycle continues
“i90” Code - family: Configuration
Problem
“i91” – code: checksum MCF
• No washing program start is possible, can be
resolved by turning the appliance Off and back to
On again.
• The display board does not satisfy the
identification requests of the main board.

Electrolux FGCD2456QW Specifications

General

Brand	Electrolux
Model	FGCD2456QW
Category	Dishwasher
Language	English