SOI 04.05 FV 10/57 599 36 62-62
3.3 BURNER CONTROL PANEL
Each burner is operated from a specific area of the control panel as indicated in the figure below.
Each of the control areas indicates the position of the corresponding burner, the touch control for
switching the burner on and off, a LED indicating residual heat, six LEDs indicating the burner
setting (level 0 is the lowest setting) and two touch controls for increasing and decreasing the
flame.
Fig. 3
ON / OFF BURNER - SWITCHES THE BURNER ON AND OFF
BURNER ZONE - INDICATES THE POSITION OF THE BURNER
RESIDUAL HEAT LED - LED INDICATING RESIDUAL HEAT
FLAME LEVEL LEDS - 6 LEDs INDICATING THE LEVEL OF THE FLAME
INCREASING FLAME - TOUCH CONTROL - INCREASES THE FLAME
DECREASING FLAME - TOUCH CONTROL - DECREASES THE FLAME
To Next Page
Loading...
